本文主要是介绍ansys apdl建模案例1-----------杯子，希望对大家解决编程问题提供一定的参考价值，需要的开发者们随着小编来一起学习吧！
用命令来对杯子进行建模
- 一、最终结果图
- 二、命令
这里没什么好讲的，主要是体会建模的思路及流程。
一、最终结果图
二、命令
/clear,start
/prep7
k,1,0,0,0 !创建关键点
k,2,0.0395,0,0
k,3,0.05,0.12,0
k,4,0.047,0.12,0
k,5,0.0367,0.003,0
k,6,0,0.003,0
lstr,1,2 !将关键点连成一条直线
lstr,2,3
lstr,3,4
lstr,4,5
lstr,5,6
lstr,6,1
lfillt,1,2,0.02 !线倒角
lfillt,4,5,0.017
al,all !将所有线连接构成一个平面
vrotat,all,,,,,,1,6,360 !将面绕1,6关键点连成的轴线旋转360°生成体
k,31,0,0.103,0
k,32,0.078,0.103,0
k,33,0.078,0.046,0
k,34,0,0.0011,0
lstr,31,32
lstr,32,33
lstr,33,34
lfillt,54,55,0.013
lfillt,55,56,0.028
k,41,0,0.105,0.005
k,42,0,0.105,-0.005
k,43,0,0.101,-0.005
k,44,0,0.101,0.005
lstr,41,42
lstr,42,43
lstr,43,44
lstr,44,41
lfillt,59,60,0.001
lfillt,60,61,0.001
lfillt,61,62,0.001
lfillt,62,59,0.001
al,59,63,60,64,61,65,62,66 !将选择的线连接成为一个平面
vdrag,33,,,,,,54,57,55,58,56 !将面33沿着线54,57,55,58,56扫掠生成体
vsel,s,,,5,9,4 !选择编号为5和9的体
asel,s,,,4,28,24 !选择编号为4和28的面
vsba,all,all !用选择的面来分割选择的体
allsel,all
vdele,10,,,1 !删除体
vdele,13,,,1
/pnum,volu,1 !打开实体编号显示
/number,1 !只显示颜色，不显示编号
/color,volu,yell,all !将所有实体颜色改为黄色
/replot
finish
这篇关于ansys apdl建模案例1-----------杯子的文章就介绍到这儿，希望我们推荐的文章对编程师们有所帮助！
