通讯模块系列DS200TCDAG1A工控卡件PLC/DCS控制卡件

产品标题: 通讯模块系列DS200TCDAG1A工控卡件PLC/DCS控制卡件

型号：DS200TCDAG1A

品牌：GE

                                                   产品详情资料：

通用电气场供应放大器板DS200FSAA2A具有5个跳线机,一个10针连接器和两个引信。它还有多个测试点。 除了10针连接器,通用电气场供应放大器板DS200fsaag2aba也有四个2针连接器,因此,板可以连接到多个电缆,必须在更换期间断开和重新连接。为了避免代价高昂的错误,可能会增加驱动器的停机时间,并使更换变得快速和容易,在磁带长度上写入电缆连接的连接器的标识符。然后,把磁带系在电缆上。只有到那时,你才能从板上断开电缆。当您准备重新连接电缆时,使用标识符定位连接器并重新连接电缆。

当您断开电缆时,请遵循一些防止损坏的指导方针。只需抓住连接器端的电缆来移除它。如果你从电缆部分拉出,它会给电缆造成压力,并可能会因拔出电线而损坏电缆。对于色带电缆来说尤其如此,因为多条电线非常精细,而且从色带到连接器的连接也没有得到很好的支持。当您重新连接它们时,请确保电缆在连接器中有完全的坐位,以便所有的信号都能通过板。如果连接器有保持夹以保持板的位置,请确保它们是连接的。

                                                      产品英文详情料:

The General Electric Field Supply Amplifier Board DS200FSAA2A has 5 jumper machines, a 10 pin connector, and two fuses. It also has multiple Test point. In addition to the 10 pin connectors, the General Electric Field Supply Amplifier Board DS200fsaag2aba also has four 2-pin connectors, so the board can be connected to multiple cables and must be disconnected and reconnected during replacement. To avoid costly errors, it may increase drive downtime and make replacement quick and easy, by writing the identifier of the cable connected connector on the tape length. Then, tie the tape to the cable. Only then can you disconnect the cable from the board. When you are ready to reconnect the cable, use the identifier to locate the connector and reconnect the cable.

When disconnecting cables, please follow some guidelines to prevent damage. Simply grab the cable at the connector end to remove it. If you pull out the cable section, it will cause pressure on the cable and may damage the cable due to pulling out the wire. This is especially true for ribbon cables, as multiple wires are very fine and the connection from the ribbon to the connector is not well supported. When you reconnect them, please ensure that the cables are fully seated in the connectors so that all signals can pass through the board. If the connectors have retention clips to maintain the position of the board, ensure that they are connected.